Wiretest T1 - Manual wire crimp pull tester

search

The pull force testers WireTest T1 from Andilog offer a quick testing solution and allow you to control the mechanical properties of the crimp termination. Especially designed to measure pull-off forces on wires and crimp terminations and supplied with two handles, a short and long, it fits applications with a capacity range from 500N up to 2000N. Equipped with its manual quick lever handle, it is suitable for production floor environment as well as quality control.

2 internal transducers available: 500N and 1,000N

A 2000N version is available, comprising a table-top housing, an external sensor and 2 wedge clamps.

From 2495 tax excl. €


Measuring direction
Tension
Accuracy
0.1% of full scale
Resolution
1/10,000 of full scale
Internal load cell sampling rate
2,000 Hz
Autonomy
15 hours
Units
N, kN, lb, kg, Oz, daN, g
Display
Color, backlight
Display type
3 lines
Overload protection
200% of full scale
Auto-off
Adjustable from 5 to 15 minuts, can be desactivated
Travel
175 mm

You might also like

Caligraph - Data...
Quick view

Caligraph - Data acquisition and analyzing software for Centor series

  • User-friendly intuitive user interface for fast start
  • Display of the curve in real time for force and torque gauges
  • Automatic pre-defined calculations: maximum, break, average
  • Creation of personalizable test reports
  • Permanent updates and support
From 595 tax excl. €