Califort material testing software

Optimize the use of your Andilog material testing equipments

With the new CALIFORT released version V5, combining your force or torque measuring device with Califort software enables you to exploit the full potential of your measuring technology application. Califort software allows you to conveniently parameterize your setup and supports you in optimizing the entire testing cycle for simple to complex application/solution. With Califort Software you benefit from:

• Intuitive and locked interfaces for the users
• Efficient and user friendly for customized test settings
• Analysis screen and wizard report edition

User-friendly intuitive user interface for fast start

The new designed interface of Califort software has been fully optimized to offer a better experience to the users and administrators. With a clear and well organized interface which facilitates reading and usability of the software for faster and efficient daily use.

Thanks to its new architecture, browsing between menus, screen and different selections has been limited to its minimum and streamline its use. Nevertheless Califort V5 remains available to use with Microsoft Windows tablets and Touch screen thanks to its integrated virtual keyboard.

Infinite number of industrial applications

While extremely easy to set thanks to the exclusive use of a dialogue window and configuration wizards, CALIFORT is able to set the most demanding sequenced test protocol. No need to use lines of codes or to know a specific language, each setting or calculation is done through the graphic interfaces.

CALIFORT comes with an extensive list of pre-defined calculations, which can be performed automatically during your tensile, compression or torsion test – It includes standard calculation such as maximum, minimum, average, or break; as well as more sophisticated calculation as Young’s modulus, modulus of elasticity, slope calculation by the method of least squares…

All movements of the material testing equipments are defined in CALIFORT under motion sequences form. Each sequence can be customized to run up, down, clockwise at different speed and with a stop condition (i.e. breaking point, force at position, time, travel position…). It also offers a cycling feature for repetitive action, with a limit of 255 cycles – for instance: achieve 3 pre-loads on a spring before measuring the stiffness or pull 5 times on a cable before measuring its tensile strength.

Personalize your results analysis

CALIFORT has an advanced report wizard feature to adapt the edition format to each industrial application. You can export measurement results in Excel or customize a report in WORD or PDF format.

Each report can be formatted to include the required data: curve, table of results, logo, test configuration used etc. It can be edited for one or to compare several test results on the same report. An editor allows users to modify the header or footer of each report for a total customization.

These report can be automatically generated at the end of the measurement, and then ensure a perfect traceability of measurements.

Permanent updates and support

ANDILOG´s software are constantly evolving, whether to add new features, new tools, improve performance or use. CALIFORT´s udpates can be downloaded, if the computer is connected to the internet. You don’t need a support contract or pay for updates.
Enjoy our telephone support without maintenance contract. The ANDILOG team is here to assist you to achieve your present and future measurements and use the best performance of our instruments and software.

> Check out the installation and training videos!

• • Compatibility :
  • Stentor II
  • Atlas II
  • Drivetwist
  • TorkHeaDriver
• • System Requirements :
  • Windows 10
  • 2 ports USB
  • 8 GB RAM
  • Intel i5 or equivalent processor
• • Generic functions :
  • User and administrator accounts
  • Update via Internet
  • Languages: English, French, German, Spanish, Polish, Italian